See 'WikiDevi' @ the Internet Archive (MW XML, Files, Images)
upgraded MW to 1.30 - maybe things are slightly less broken

WikiDevi:DD-WRT/Settings

From WikiDevi
Jump to: navigation, search

Multiple links on this site refer to important settings required for a successful flash. In addition, they ask users to use what may be unfamiliar terms. Here is an explanation of some of them. Please also see Security. Thank you - clock.

Change Ethernet Address[edit]

  1. To change your ethernet address, subnet, or gateway in Windows (instructions refer to Windows Vista:
    1. Go to Network Connections (Vista: Control Panel->Network and Internet -> Network Connections).
    2. Right click on Local Area Connection and select Properties.
    3. Click on TCP/IPv4 (at least on ) and hit Properties.
    4. Click on "Use the following IP address" and input the numbers as provided in the Hardware-specific instructions.

Change Subnet[edit]

Change Gateway[edit]

Disable Compound TCP[edit]

  1. Vista and some other operating systems have something called "Compound TCP". [1]. If enabled, it may prevent a successful installation. To accomodate it, you have to:
    1. Go to the command prompt (go to lower left of your screen, hit the icon ("Start" or a circle) and write CMD in the input/search area right above your cursor. A black screen will emerge).
    2. See this link [2] for specific commands for your particular operating system.
    3. You will have to disable it while updating your modem, then enable it again at the end.

Disable Wireless[edit]

  1. You must disable wireless during almost any modem firmware changes. Simply logging off your wireless will not work.
    1. Go to Network Connections (Vista: Control Panel->Network and Internet -> Network Connections).
    2. Double click on Wireless Internet Connection and hit Disable at the bottom of the screen.

Enable TFTP[edit]

  • Wise to do even if you do not intend to use it; if the web GUI goes down, you may have to. See TFTP Tools.

Hard Reset or 30/30/30 Reset[edit]

Ping[edit]

  1. Go to the cmd screen (Windows: go to lower left of your screen, hit the icon ("Start" or a circle) and write CMD in the input/search area right above your cursor. A black screen will emerge).
  2. To ping a modem, enter "ping 192.168.1.1" (or whatever the modem should be). Hit enter.

Power Cycle[edit]

  • Simply means unplugging your router, waiting about 10 seconds, and plugging it back in.