See 'WikiDevi' @ the Internet Archive (MW XML, Files, Images)
upgraded MW to 1.30 - maybe things are slightly less broken

Arcadyan WA9117A-AC23

From WikiDevi
Jump to: navigation, search

Arcadyan WA9117A AC23-99 (R01)

(Est.) release date: 14 November 2014

Type: wireless router

FCC ID: K7SF9K1118V2

Power: 12 VDC, 2.5 A
Connector type: barrel

CPU1: Broadcom BCM47081A0 (800 MHz)
FLA1: 32 MiB
33,554,432 B
262,144 Kib
32,768 KiB
256 Mib
0.0313 GiB
(Macronix MX25L25635FMI-10G)
RAM1: 128 MiB
134,217,728 B
1,048,576 Kib
131,072 KiB
1,024 Mib
0.125 GiB
(EtronTech EM6GC16EWXD-12H)

Expansion IFs: USB 3.0, USB 2.0
USB ports: 2

WI1 chip1: Broadcom BCM4360
WI1 802dot11 protocols: an+ac
WI1 MIMO config: 3x3:3
WI1 antenna connector: none
WI2 chip1: Broadcom BCM43217
WI2 802dot11 protocols: bgn
WI2 MIMO config: 2x2:2
WI2 antenna connector: none

ETH chip1: Broadcom BCM47081A0
Switch: Broadcom BCM47081A0
LAN speed: 10/100/1000
LAN ports: 4
WAN speed: 10/100/1000
WAN ports: 1

abgn+ac

Additional chips
2.4GHz Power Amplifier IC;Richwave;RTC6649E;747, 649E, 447;2;
5GHz Power Amplifier IC;Skyworks;SE5003L1;;3;

802dot11 OUI: none specified

 FCC ID
Belkin F9K1118 v2K7SF9K1118V2
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.


Wireless-AC Dual-Band Gigabit Router

Product page (WG9117G-AC)

"P/N:141911723099J R01" is silkscreened on the main board.

See also Belkin F9K1118 v2 and Belkin F9K1118 v1..

Wi-Fi Certified (alt.) (as of 11/14/2014)

Forum threads[edit]

Serial[edit]

boot log (firmware 001.007.76)
Decompressing...done

Found a ST compatible (Macronix) serial flash with 512 64KB blocks; total size 32MB
find_nvram(256): slf_info=00f56e3c, flbase=1e000000, lim=02000000
find_nvram(293): nvh=1fff0000, off=02000000 NVRAM founded.

CFE version 6.37.14.105 (r485445) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Fri Nov  7 16:05:39 CST 2014 (linghong_tan@sw1.2)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.

Boot partition size = 262144(0x40000)
IMAGE_FIRST_OFFSET=262144,IMAGE_SECOND_OFFSET=16777216
DDR Clock: 533 MHz
Warning: using legacy sdram_ncdl parameter to set DDR frequency. 
Equivalent setting in clkfreq=800,*0* will be ignored.
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.14.105 (r485445)

CPU type 0x0: 800MHz
Tot mem: 131072 KBytes

CFE mem:    0x00F00000 - 0x00FE1CDC (924892)
Data:       0x00F55DEC - 0x00F563EC (1536)
BSS:        0x00F563F8 - 0x00F7BCDC (153828)
Heap:       0x00F7BCDC - 0x00FDFCDC (409600)
Stack:      0x00FDFCDC - 0x00FE1CDC (8192)
Text:       0x00F00000 - 0x00F494F8 (300280)
Boot:       0x00FE2000 - 0x01022000
Reloc:      I:00000000 - D:00000000

Copying boot params.....
DONE

Bootloader version a1.3.4
Project name : WA9117

Press space bar to cancel startup...
Device eth0:  hwaddr 4C-09-D4-00-00-00, ipaddr 192.168.1.254, mask 255.255.255.0
        gateway not set, nameserver not set
Booting(0): boot -raw -z -addr=0x8000 -max=0xef8000 flash0.os:
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)

Loading: .... 4600576 bytes read
Entry at 0x00008000
Closing network.
Starting program at 0x00008000
console [ttyS0] enabled, bootconsole disabled
serial8250.0: ttyS1 at MMIO 0x18000400 (irq = 117) is a 16550
brd: module loaded
loop: module loaded
pflash: found no supported devices

The first offset=40000, 2nd offset=1000000
bcmsflash: squash filesystem found at block 34
Detect first image vmlz_off=50000,rfs_off=224db8,size=2000000
boot partition is writable
boot param partition is writable
bcmsflash: squash filesystem found at block 286
Detect second image offset=1010000,rfs_off=11e4d70,size=2000000

Creating 8 MTD partitions on "bcmsflash":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x000000050000 : "bootp"
0x000000050000-0x000001010000 : "linux"
0x000000224db8-0x000001010000 : "rootfs"
0x000001010000-0x000001fe0000 : "linux2"
0x0000011e4d70-0x000001fe0000 : "rootfs2"
0x000001fe0000-0x000001ff0000 : "nvram2"
0x000001ff0000-0x000002000000 : "nvram"

nflash: found no supported devices
PPP generic driver version 2.4.2
NET: Registered protocol family 24
usbmon: debugfs is not available
usbcore: registered new interface driver usblp
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
u32 classifier

    Actions configured

Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (1954 buckets, 7816 max)
ctnetlink v0.93: registering with nfnetlink.
xt_time: kernel timezone is -0000
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Northstar brcmnand NAND Flash Controller driver, Version 0.1 (c) Broadcom Inc. 2012
brcmnand: found no supported devices
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
devtmpfs: mounted
Freeing init memory: 224K
/sbin/hotplug2: No such file or directory
modprobe: module 'ipv6' not found
modprobe: module 'bcm57xx' not found
hotplug detected product:  1d6b/3/206
hotplug detected product:  1d6b/3/206
hotplug detected product:  1d6b/2/206
hotplug detected product:  1d6b/2/206
hotplug detected product:  1d6b/1/206
hotplug detected product:  1d6b/1/206

devpath=[/dev/mtd2]
SHA256=[c21fdfcfc0173a1587930bb4c3148da350baa7b85b38d355d2e8aef4a753442f]
Hit enter to continue...